WRDM W0 00000012
WRDM W0 00000013
ADDR
0000000000111111111122222222223333333333444444444455555555556666
0123456789012345678901234567890123456789012345678901234567890123
00 +++++++++++++++++++++X++++++++S+++++++++++++++++++++++++--------
0000001B =>00000015
CZS#!@#@
BCM97358A1 CFE v3.20, Endian Mode: Little
Build Date: Thu Jul 17 00:00:00 CEST 2014 (root@gb800ueplus)
Copyright (C) Broadcom Corporation.
CPU speed: 751MHz
DDR Frequency: 796 MHz
DDR Mode: DDR3
Total memory(MEMC 0): 512MB
MEMC 0 DDR Width: 16
Boot Device: NAND
Total flash: 256MB
RTS VERSION: Initial RTS Version
ETH0_PHY: INT
ETH0_MDIO_MODE: 1
ETH0_SPEED: 100
ETH0_PHYADDR: 1
Initializing USB.
USB: Locating Class 09 Vendor 0000 Product 0000: USB Root Hub
CFE initialized.
USB: Device disconnected from bus 0 hub 1 port 1
USB: New device connected to bus 0 hub 1 port 1
USB: Resetting device on bus 0 hub 1 port 1
USB: Locating Class FF Vendor 048D Product 9006: Driver not found.
USB device matching <USB Disk> not found!
Starting splash screen.
Found splash image - Width = 720 Height = 576
Non Interlaced Replace list 0ebe47b0 0f000000Interlaced Replace list 0ebe52f0 00
Reading flash0.lcdsplash: No valid image found in flash0.lcdsplash - disabling h
Failed: Error
Loader:elf Filesys:raw Dev:flash0.kernel File: Options:(null)
Loading: 0x80001000/8194052 0x807d1804/170572 Entry address is 0x80619030
Starting program at 0x80619030
Linux version 3.14.2 (lonas@lonas-linux) (gcc version 4.9.1 (GCC) ) #1 Sat Oct 4
Fetching vars from bootloader... found 15 vars.
Options: moca=0 sata=0 pcie=0 usb=1
Using 512 MB + 0 MB RAM (from CFE)
MEMC0 split: 256 MB -> Linux; 256 MB -> extra bmem
bootconsole [early0] enabled
CPU0 revision is: 00029032 (Broadcom BMIPS3300)
Determined physical RAM map:
memory: 10000000 @ 00000000 (usable)
bmem: adding 24 MB RESERVED region at 232 MB (0x01800000@0x0e800000)
Zone ranges:
Normal [mem 0x00000000-0x0fffffff]
Movable zone start for each node
Early memory node ranges
node 0: [mem 0x00000000-0x0fffffff]
Primary instruction cache 32kB, VIPT, 4-way, linesize 16 bytes.
Primary data cache 32kB, 2-way, VIPT, cache aliases, linesize 16 bytes
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 65024
Kernel command line: bmem=24M bmem=256M@512M ubi.mtd=rootfs root=ubi0:rootfs ro8
PID hash table entries: 1024 (order: 0, 4096 bytes)
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 227100K/262144K available (6275K kernel code, 349K rwdata, 1180K rodata)
NR_IRQS:160
Measuring MIPS counter frequency...
Detected MIPS clock frequency: 751 MHz (375.748 MHz counter)
Console: colour dummy device 80x25
Calibrating delay loop... 749.56 BogoMIPS (lpj=374784)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
devtmpfs: initialized
bmem: adding extra 256 MB RESERVED region at 512 MB (0x10000000@0x20000000)
NET: Registered protocol family 16
USB0: power enable is active high; overcurrent is active low
bio: create slab <bio-0> at 0
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
Linux video capture interface: v2.00
Advanced Linux Sound Architecture Driver Initialized.
Bluetooth: Core ver 2.18
NET: Registered protocol family 31
Bluetooth: HCI device and connection manager initialized
Bluetooth: HCI socket layer initialized
Bluetooth: L2CAP socket layer initialized
Bluetooth: SCO socket layer initialized
Switched to clocksource wktmr
FS-Cache: Loaded
cfg80211: Calling CRDA to update world regulatory domain
NET: Registered protocol family 2
TCP established hash table entries: 2048 (order: 1, 8192 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP: reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
RPC: Registered named UNIX socket transport module.
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
RPC: Registered tcp NFSv4.1 backchannel transport module.
futex hash table entries: 256 (order: -1, 3072 bytes)
NFS: Registering the id_resolver key type
Key type id_resolver registered
Key type id_legacy registered
nfs4filelayout_init: NFSv4 File Layout Driver Registering...
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
fuse init (API version 7.22)
msgmni has been set to 443
io scheduler noop registered
io scheduler cfq registered (default)
Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0x10406800 (irq = 62, base_baud = 5062500) is a 165A
console [ttyS0] enabled
console [ttyS0] enabled
bootconsole [early0] disabled
bootconsole [early0] disabled
serial8250.0: ttyS1 at MMIO 0x10406840 (irq = 63, base_baud = 5062500) is a 165A
serial8250.0: ttyS2 at MMIO 0x10406880 (irq = 64, base_baud = 5062500) is a 165A
loop: module loaded
brcmstb_nand: NAND controller driver is loaded
bcmgenet: configuring instance #0 for internal PHY
bcmgenet bcmgenet.0 eth0: link down
ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
ehci-brcm ehci-brcm.0: Broadcom STB EHCI
ehci-brcm ehci-brcm.0: new USB bus registered, assigned bus number 1
ehci-brcm ehci-brcm.0: irq 66, io mem 0x10480300
ehci-brcm ehci-brcm.0: USB 0.0 started, EHCI 1.00
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
ohci-brcm ohci-brcm.0: Broadcom STB OHCI
ohci-brcm ohci-brcm.0: new USB bus registered, assigned bus number 2
ohci-brcm ohci-brcm.0: irq 67, io mem 0x10480400
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
usbcore: registered new interface driver usb-storage
mousedev: PS/2 mouse device common for all mice
i2c /dev entries driver
IR NEC protocol handler initialized
IR RC5(x) protocol handler initialized
IR RC6 protocol handler initialized
IR JVC protocol handler initialized
IR Sony protocol handler initialized
IR RC5 (streamzap) protocol handler initialized
IR SANYO protocol handler initialized
IR MCE Keyboard/mouse protocol handler initialized
usbcore: registered new interface driver btusb
hidraw: raw HID events driver (C) Jiri Kosina
usbcore: registered new interface driver usbhid
usbhid: USB HID core driver
TCP: cubic registered
NET: Registered protocol family 17
Bluetooth: HIDP (Human Interface Emulation) ver 1.2
Bluetooth: HIDP socket layer initialized
Key type dns_resolver registered
PM: CP0 COUNT/COMPARE frequency depends on divisor
EBI CS0: setting up NAND flash (primary)
nand: device found, Manufacturer ID: 0x01, Chip ID: 0xda
nand: AMD/Spansion S34ML02G1
nand: 256MiB, SLC, page size: 2048, OOB size: 64
nand: device found, Manufacturer ID: 0x01, Chip ID: 0xda
nand: AMD/Spansion S34ML02G1
nand: 256MiB, SLC, page size: 2048, OOB size: 64
brcmnand brcmnand.0: 256MiB total, 128KiB blocks, 2KiB pages, 16B OOB, 8-bit, HC
Bad block table found at page 131008, version 0x01
Bad block table found at page 130944, version 0x01
Creating 4 MTD partitions on "brcmnand.0":
0x000000e00000-0x00000fc00000 : "rootfs"
0x000000e00000-0x00000fc00000 : "rootfs(redundant)"
0x000000200000-0x000000900000 : "kernel"
0x000000900000-0x000000a00000 : "mac"
UBI: attaching mtd0 to ubi0
usb 1-1: new high-speed USB device number 2 using ehci-brcm
input: ITE Technologies, Inc. USB Deivce as /devices/platform/ehci-brcm.0/usb1/0
hid-generic 0003:048D:9006.0001: input,hidraw0: USB HID v1.01 Keyboard [ITE Tec1
random: nonblocking pool is initialized
UBI: scanning is finished
UBI: attached mtd0 (name "rootfs", size 238 MiB) to ubi0
UBI: PEB size: 131072 bytes (128 KiB), LEB size: 126976 bytes
UBI: min./max. I/O unit sizes: 2048/2048, sub-page size 2048
UBI: VID header offset: 2048 (aligned 2048), data offset: 4096
UBI: good PEBs: 1904, bad PEBs: 0, corrupted PEBs: 0
UBI: user volume: 1, internal volumes: 1, max. volumes count: 128
UBI: max/mean erase counter: 18/9, WL threshold: 4096, image sequence number: 89
UBI: available PEBs: 0, total reserved PEBs: 1904, PEBs reserved for bad PEB ha0
ALSA device list:
No soundcards found.
UBI: background thread "ubi_bgt0d" started, PID 45
UBIFS: background thread "ubifs_bgt0_0" started, PID 46
UBIFS: recovery needed
UBIFS: recovery completed
UBIFS: mounted UBI device 0, volume 0, name "rootfs"
UBIFS: LEB size: 126976 bytes (124 KiB), min./max. I/O unit sizes: 2048 bytes/2s
UBIFS: FS size: 234778624 bytes (223 MiB, 1849 LEBs), journal size 9023488 byte)
UBIFS: reserved for root: 0 bytes (0 KiB)
UBIFS: media format: w4/r0 (latest is w4/r0), UUID C9A9DBAA-8693-4850-B36D-CED5l
VFS: Mounted root (ubifs filesystem) on device 0:10.
devtmpfs: mounted
Freeing unused kernel memory: 244K (807a3000 - 807e0000)
Algorithmics/MIPS FPU Emulator v1.5
INIT: version 2.88 booting
usbcore: registered new interface driver rtl8192cu
version: 20141019225038-14.2
LCD: ILI9226
input: gigablue remote control as /devices/virtual/input/input1
DVB: registering new adapter (gbueplus)
dvb dvb.0: DVB: registering adapter 0 frontend 0 (BCM7346 DVB-S2 NIM (internal).
boxmodel: module license 'proprietary' taints kernel.